1/2 Pound kit XTR-311 Epoxy Adhesive

$80.00
SKU
XTR-.5
 
XTR-311 is a water clear, low viscosity, two part epoxy for laminating and bonding glass. It is also fantastic for crack repair due to it's lower viscosity. The epoxy is mixed 10:3 and cures in roughly 36 hours. It will remain clear for the life of the joint and can be colored if required.
  • XTR-311 is a two part epoxy consisting of a Resin and a Hardener mixed 10:3 by weight
  • Specific gravity- 1.15
  • Viscosity - 500cps
  • Index of Refraction - 1.517
  • Shore D Hardness - 82
  • Cure time - 36 hours, 48 hours for full bond cure
Write Your Own Review
You're reviewing:1/2 Pound kit XTR-311 Epoxy Adhesive
Your Rating
Customer Questions
Do I measure the epoxy parts as ten drops to 3 drops or as weight, as with Hx-tal? I've been using Hxtal but am hoping that his glue will work for my purposes as I greatly prefer the drying time. I glue condiment containers (not always perfectly flat) to the bottom of flat glass to use as a paraffin reservoir for candles. Thanks.
Hxtal is measured by weight using a gram scale.
After bonding two glass faces and allowing the joint to fully cure, can you continue grinding and polishing the bonded pieces along with the epoxy seam/joint? Will the seam polish?
You can still grind and polish the joint with very little visibility. The larger the layer of glue the more visible it would be though. Hxtal is more of a plastic so it doesnt polish the same as glass. If you were to go a gap fill then work the surface...
Please, mind that only logged in users can submit questions
We found other products you might like!
Copyright © 2024 His Glassworks, Inc. All rights reserved.